|
This is
Loubie's Adalinda
while printing on Vertex 3D Delta K8800. The filament was Innofil3D Orange translucent.
|
|
The display of my Vertex 3D Delta K8800. I made a small program that changes gcode files so that the curen Layer/Max Layer and Type is shown on
the LCD source.
|
|
Lubrication of the rods is very important.
In the beginning some black patina appears.
|
|
The extruder of my Vertex 3D Delta K8800 and the yellow and blue LED of yhe end stop.
|
|
Printing
Spiral Vase by Yllonnoce in the dark. The printhead LEDs are really nice!
|
|
|
|
This is Baby Groot
by Byambaa.
|
|
Printing of Baby Groot was finshed after less than 9 hours.
|
|
|
|
This is a failed print of
The 3D Printed Marble Machine #3 by Tulio
Lower part: Filament: Janbex PLA pure Line2
This really bad! It get stuck 8 times. Some of the cullumns broke
because of underextruseion caused by jammed filament.
Upper part: Innofil3d blue translucent only 3 times jammed
in that much bigger part. Finally the printhead colided at some
point so that next layer was shifted horizontally. After 12:40 hours!
|
|
Printed things after the fist week with Vertex 3D Delta K8800.
|
|
|
|
|
|
|
|
|
|
This is Aria the Dragon
by loubie printed on Vertex 3D Delta K8800 with Innofil3D Orange translucent filament.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This is
Hex surface vase (spiral print)by DrLex May
Innofil3D EPR-InnoPET.
|
|
This is Spiral Vase
by Yllonnoce scaled to 210mm height and 190mm diameter while printed on Velleman Vertex 3D Delta K8800.
Note the printhead can be seen on the other side of the Aluminium risers.
Filament: Janbex PLA pure Line2
|
|
|
|
|
|
This is Spiral Vase
by Yllonnoce scaled to 210mm height and 190mm diameter while
printed on Velleman Vertex 3D Delta K8800. Filament: Janbex PLA pure Line2
|